DeVille d Elegance V8-4.6L VIN Y (1998)
Alignment: Specifications
Vehicle Ride (Trim) Height Specifications
D ............................................................................................................................................................................................................... 37 mm (1.46 inch)
Z ................................................................................................................................................................................................................ 51 mm (2.01 inch)
J .............................................................................................................................................................................................................. 192 mm (7.56 inch)
K ............................................................................................................................................................................................................. 202 mm (7.95 inch)
P ............................................................................................................................................................................................................ 707 mm (27.83 inch)
R ........................................................................................................................................................................................................... 543 mm (21.38 inch)
* All measurements are plus or minus 10 mm (0.04 in).
* Maximum variation side-to-side is 12 mm (0.05 in).
"D" Specification Measurement:
D Measurement
Measure the clearances (D) between the centerline of the front inner bearing bushing bolt (3) and the centerline of the front outer bushing bolt (1) (this
measurement should be taken on the front side of the rear suspension assembly).
"Z" Specification Measurement:
Z Measurement
Measure the clearance (Z) between the centerline of the bushing bolt (1) and the lowest point on the ball joint (3) (excluding the grease fitting).
"J,K,P,R" Specification Measurement:
