DeVille DHS V8-4.6L VIN Y (2000)
Installation Procedure
1. Install the window regulator (1) through the access hole of the inner door panel.
Notice: Refer to Fastener Notice in Cautions and Notices.
2. Install the window regulator fasteners (2).
Tighten the fasteners to 9 N.m (80 lb in).
3. Connect the electrical connector to the window regulator motor.
Important: Ensure that the rubber insulators are properly attached to the window regulator clamps.
4. Carefully raise the window regulator clamps (2) to the full up position, engaging the window (1).
5. Remove the tape from the window.
6. Complete the following to properly position the window:
1. Lower the window approximately 2 in.
2. Seat the window fully rearward against the center pillar.
3. Adjust the window forward 2-3 mm (5/64-1/8 in).
4. Set the glass with the clamp fasteners.
Tighten the window clamp fasteners to 10.5 N.m (93 lb in).
7. Disconnect the power window switch and module.
8. Position the rear of the inside handle assembly (1) into the opening of the inner panel.
9. Press the front of the assembly (1) inward until it fully engages the inner panel.
