DeVille DHS V8-4.6L VIN Y (2000)
Installation Procedure
1. Tap the mount into the support assembly ensuring the flat is outboard (2) and the notch (1) is rearward upon the installation.
2. Bend the tabs outboard with a large pair of pliers, Tabs should be fully seated against chamfer in support assembly retainer ring.
3. Raise the support assembly to the body of the vehicle.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install two bolts securing the front of the support assembly to the vehicle body.
Tighten the bolts to 187 Nm (138 ft. lbs.).
5. Install the support bracket to body bolts (1).
Tighten the support bracket to body bolts to 128 Nm (94 ft. lbs.)
6. Install the brackets to body at the support assembly forward mounts.
Tighten insulator to body bracket bolts to 86 Nm (63 ft. lbs.).
