DeVille DHS V8-4.6L VIN Y (2000)
Power Seat Switch: Service and Repair
Power Seat Switch Replacement
Tools Required
J 38778 Door Trim Pad Clip Remover
Removal Procedure
Caution: Refer to SIR Caution.
1. Adjust the front seat to the up position until maximum travel is reached.
Angle the front of the seat cushion up in order to access the seat cushion fasteners.
2. Remove the fasteners retaining the cushion to the seat adjuster.
3. Disconnect the front heated seat cushion electrical connectors and the lumbar air lines, if equipped.
4. Remove the knobs from the switch.
5. Remove the two push pins from the inside of the switch trim plate, on the bottom edge of the trim plate.
6. Release the tabs at the bottom of the switch plate.
7. Remove the switch trim plate.
8. Remove the J channels from the seat cushion.
9. Peel the front seat cushion cover up in order to expose the switch.
10. Using the J 38778, remove the switch bracket retainers.
