DeVille DHS V8-4.6L VIN Y (2000)
11.
Match the edges of the factory heat element material and cover the cut-lines with 3M(R) Highland(TM) Cloth Duct Tape, P/N 6969, or equivalent.
Ensure the service and factory heat elements are laying flat.
12.
On DHS & DTS seat cushion installations: Connect the two thigh heat element electrical connectors to the center heat element.
13.
Install the seat trim cover. Refer to the appropriate seat trim cover installation procedure in the Seats sub-section of the Service Manual.
14.
On front seat assembly installations: Install the fasteners that retain the seat cushion to the seat adjuster.
Tighten
Tighten the fasteners to 9 N.m (80 lb in).
15.
Place the seat assembly inside the vehicle. DO NOT install at this time.
16.
Verify the seat heat function is operational.
17.
Complete the seat assembly installation. Refer to the appropriate seat replacement procedure in the Seats sub-section of the Service Manual.
