DeVille DHS V8-4.6L VIN Y (2000)
Brake Caliper: Service and Repair
Brake Caliper Bracket Replacement - Rear (J55)
Removal Procedure
1. Remove 2/3 of the brake fluid from the master cylinder.
2. Raise and support the vehicle. Refer to Vehicle Lifting.
3. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Wheels, Tires and Alignment.
4. Inspect the caliper operation. Refer to Brake Caliper Inspection.
5. Remove the caliper. Refer to Brake Caliper Replacement - Rear (J55). Remove the caliper and mounting bracket from the backing plate. Refer to
Brake Pads Replacement - Rear (J55).
7. Inspect the caliper and mounting bracket. Refer to Brake Caliper Inspection.
Installation Procedure
1. Install the brake caliper mounting bracket.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the brake caliper mounting bracket bolts.
^
Tighten the mounting bolts to 128 Nm (94 ft. lbs.).
3. Install the brake caliper. Refer to Brake Caliper Replacement - Rear (J55).
4. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Wheels, Tires and Alignment.
5. Remove the safety stands.
6. Lower the vehicle.
7. Pump the brake pedal slowly and firmly in order to seat the brake pads.
