DeVille DHS V8-4.6L VIN Y (2000)
2. Install the brake pad retainers (1) into the caliper anchor bracket (5).
3. Snap the brake pad wear sensor into the inboard brake pad.
4. Install the inboard (2) and outboard (3) brake pads into the caliper anchor bracket. Route the wear sensor wire through the caliper and support
properly to be sure the wire will lay in its proper location when the caliper is installed.
Important: The caliper piston boot must lay flat. Make sure convolutions are tucked into place.
5. Use a small plastic or wooden tool (1) to lift the inner edge of the boot next to the piston, and press out any trapped air.
6. Pivot the caliper down over the brake pads and into the anchor bracket. Be sure that the wear sensor wiring is properly routed and clipped in its
original location.
