DeVille DHS V8-4.6L VIN Y (2000)
6. Install the 2 BPMV bracket nuts (2).
^
Tighten the 2 nuts to 10 Nm (89 inch lbs.).
Caution: Make sure brake pipes are correctly connected to BPMV. If brake pipes are switched by mistake (Inlet vs. Outlet), wheel lockup
will occur and personal injury may result.
Important: If a new BPMV is being installed, remove the shipping plugs from the valve openings.
7. Install the 4 wheel brake pipes (1) to the BPMV (2) using the locations recorded during the removal procedure.
^
Tighten the 4 brake pipes to 15 Nm (11 ft. lbs.).
8. Install 2 master cylinder brake pipes (1 ) to the BPMV (2) using the locations recorded during the removal procedure.
^
Tighten the 2 brake pipes to 15 Nm (11 ft. lbs.).
