DeVille DHS V8-4.6L VIN Y (2000)
10. Remove the four spark plug boots.
11. Disconnect the cable harness clips at the front of the camshaft cover and position the cable harness aside.
12. Remove the nine camshaft cover bolts.
13. Remove the camshaft cover.
14. Discard the camshaft cover seal if there is any evidence of damage or if the seal comes out of the groove in the cover during removal.
15. Clean and inspect the camshaft cover. Refer to Camshaft Cover Clean and Inspect.
Installation Procedure
1. Install the camshaft cover seal as required.
Important: Be careful to prevent the exposed section of the camshaft cover seal from being damaged by the edge of the cylinder head casting.
2. Install the camshaft cover.
Notice: Refer to Fastener Notice in Service Precautions.
