DeVille DHS V8-4.6L VIN Y (2000)
Door Switch: Service and Repair
REMOVAL PROCEDURE
1. Insert a flat bladed tool under the rear edge of the door switch plate.
IMPORTANT: Before lifting the switch plate from the door trim panel, ensure that the flat bladed tool has fully disengaged the retainer clip.
Otherwise damage to the switch plate or the retainer clip may occur.
2. Push the tool firmly towards the switch plate to disengage the retention clip.
3. Lift up on the rear of the switch plate and remove it from the door trim panel.
4. Disconnect electrical connector.
5. Remove the appropriate switch from the switch plate by disengaging the side snap walls with small flat bladed tool.
INSTALLATION PROCEDURE
