DeVille DHS V8-4.6L VIN Y (2000)
1. With all eight crossover retaining bolts inserted, slide the upper and lower water housing crossover gaskets onto the bolts.
Important: Care should be taken when installing the water housing bolts, so that the gaskets are in the correct position.
2. Place the water housing crossover in position and hand start the bolts to hold the crossover in place.
Notice: Refer to Fastener Notice in Service Precautions.
3. Tighten the water housing crossover bolts in sequence.
Tighten the bolts to 25 Nm (18 ft. lbs.).
4. Connect the heater hose to the water housing crossover.
5. Connect the cable harness clip to the water housing crossover.
6. Install the two bolts (3) attaching the water pump belt tensioner (1) to-the water crossover.
Tighten the two bolts (3) to 10 Nm (89 inch lbs.).
7. Install the water pump. Refer to Water Pump Replacement.
