DeVille DHS V8-4.6L VIN Y (2000)
6. Pull the connection apart.
NOTE: If necessary, remove rust or burrs from the fuel pipes with an emery cloth. Use a radial motion with the fuel pipe end in order to prevent
damage to the O-ring sealing surface. Use a clean shop towel in order to wipe off the male tube ends. Inspect all the connections for dirt and burrs.
Clean or replace the components and assemblies as required.
7. Using a clean shop towel, wipe oft the male pipe end.
8. Inspect both ends of the fining for dirt and burrs. Clean or replace the components as required.
INSTALLATION PROCEDURE
CAUTION: In order to reduce the risk of fire and personal injury, before connecting fuel pipe fittings, always apply a few drops of clean
engine oil to the male pipe ends.
This will ensure proper reconnection and prevent a possible fuel leak
During normal operation, the O-rings located in the female connector will swell and may prevent proper reconnection it not lubricated.
1. Apply a few drops of clean engine oil to the male pipe end.
2. Push both sides of the fining together to cause the retaining tabs to snap into place.
3. Once installed, pull on both sides of the fitting to make sure the connection is secure.
