DeVille DHS V8-4.6L VIN Y (2000)
44. Twist together, bend, and tape the remaining connector wire lead to the remaining deployment wire.
45. Connect the deployment harness to the inflatable restraint rear seat side impact inflator module yellow 2-way connector.
46. Route the deployment harness out of the driver side of the vehicle.
47. Disconnect the inflatable restraint IP module yellow 2-way harness connector (1) from the vehicle harness connector (2) located above passenger
side sound insulator.
48. Cut the harness connector out of the vehicle, leaving at least 16 cm (6 in) of wire at the connector.
49. Strip 13 mm (0.5 in) of insulation from each of the connector wire leads.
