cadillac Workshop Repair Guides

Cadillac Workshop Service and Repair Manuals

Side Air Bag|Description and Operation > < Side Impact Air Bag Inflator Module - Replacement Update
Page 1
background image

Side Air Bag: Service Precautions

CAUTION:  When you are performing service on or near the SIR components or the SIR wiring, you must disable the SIR system. Refer to
Disabling the SIR System. Failure to follow the correct procedure could cause air bag deployment, personal injury, or unnecessary SIR system
repairs.

The inflatable restraint Sensing and Diagnostic Module (SDM) maintains a reserve energy supply. The reserve energy supply provides deployment
power for the air bags. Deployment power is available for as much as 10 seconds after disconnecting the vehicle power by any of the following methods:

^

Turn OFF the ignition.

^

Remove the fuse that provides power to the SDM.

^

Disconnect the vehicle battery from the vehicle electrical system.

Disabling the SIR system prevents deploying of the air bags from the reserve energy supply power.

CAUTION:

^

In order to avoid deploying the air bag when troubleshooting the SIR system, use only the equipment specified in this manual and the
Instructions given in this manual Failure to use the specified equipment as instructed could cause air bag deployment, personal injury to
you or someone else, or unnecessary SIR system repairs.

^

If any water enters the vehicle's interior up to the level of the carpet or higher and soaks the carpet, the sensing and diagnostic module
(SDM) and the SDM harness connector may need to be replaced. The SDM could be activated when powered, which could cause
deployment Of the air bag(s) and result in personal Injury Before attempting these procedures, the SIR system must be disabled. Refer to
Disabling the SIR System

With the ignition OFF, Inspect the SDM mounting area, including the carpet. If any significant soaking or evidence of significant soaking is
detected, you must perform the following tasks:

1. Remove all water.
2. Repair the water damage.
3. Replace the SDM harness connector.
4. Replace the SDM.

Failure to follow these tasks could result In possible air bag deployment, personal injury, or otherwise unneeded SIR system repairs.

Side Air Bag|Description and Operation > < Side Impact Air Bag Inflator Module - Replacement Update