DeVille DHS V8-4.6L VIN Y (2000)
5. Remove the Connector Position Assurance (CPA) (1) from the inflatable restraint sensing and diagnostic module (SDM) wiring harness connector
(2).
6. Push down flex lock button (3) and then move sliding connector locking cover (4) to the open position.
7. Remove push-on clip (1) securing SDM wiring harness to console stud.
8. Disconnect the SDM wiring harness connector (3) from the SDM (2).
9. Remove the SDM mounting fasteners (1).
10. Remove the SDM (2) from the console floor (3).
INSTALLATION PROCEDURE
