DeVille DHS V8-4.6L VIN Y (2000)
Important: Maintain the twisting of the wheel speed sensor wires.
1. Install the terminals (2) and cable seals (3) to the engine side of the wire. Refer to Wiring Repairs in Diagnostic Aids.
2. Install the connector (1) and terminal position assurance (4) to the engine side of the wire. Refer to Wiring Repairs in Diagnostic Aids.
3. Install the wheel speed sensor jumper connector (2) to the assembled connector (3).
4. Route the wheel speed sensor jumper (1 ) through the engine compartment to the wheel well.
5. Raise the vehicle. Refer to Vehicle Lifting.
6. Install the wheel speed sensor connector (7) to the wheel speed sensor (6).
7. Install the harness grommet (3) to the strut bracket (5).
8. Install the harness grommet (1 ) to the rail bracket (2).
9. Install the harness clip (4) the rail bracket (2).
10. Install the left front wheel. Refer to Tire and Wheel Removal and Installation in Wheels, Tires and Alignment.
11. Lower the vehicle. Refer to Vehicle Lifting.
