DeVille DHS V8-4.6L VIN Y (2000)
6. Reposition the protective boot from the generator output BAT terminal for access.
7. Remove the generator output BAT terminal nut and disconnect the positive lead from the generator.
8. Disconnect the cable harness clips from the front of the camshaft cover.
9. Remove the generator cable from the vehicle.
INSTALLATION PROCEDURE
1. Position the generator cable to the engine.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants,
or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may
damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
2. Connect the battery positive lead and install the generator output BAT terminal nut.
Tighten the generator output BAT terminal nut to 12.5 N.m. (111 lb in).
3. Press the protective boot on to the generator output BAT terminal.
4. Connect the cable harness clips to the front of the camshaft cover.
