DeVille DHS V8-4.6L VIN Y (2000)
8. Place the transmission in PARK.
9. Using J28733-B separate hub and bearing from the drive axle.
Installation Procedure
Important: Clean rust and foreign material from the knuckle mounting face, bore and chamfer to allow for proper seating of the bearing and knuckle.
1. Install the hub and bearing to the drive axle.
^
Apply a light coating of grease to the knuckle bore. If the new hub and bearing has a protective plastic cover, remove it before installation.
^
Do not handle the knuckle or hub assembly by the ABS sensor wire.
2. Install the drive axle nut and draw hub and bearing onto the axle.
3. Place the transmission in neutral.
4. Install the dust shield, taking care not to damage the bearing outboard lip seal
Notice: Refer to Fastener Notice in Service Precautions.
5. Install the hub and bearing bolts.
Tighten the hub and bearing bolts to 152 Nm (112 ft. lbs.).
6. Install the front wheel speed sensor connector and clip to the dust shield.
7. Install the rotor. Refer to Brake Rotor Replacement - Front (Without J55) or Brake Rotor Replacement - Front (J55) in Brakes and Traction
Control.
