DeVille DTS V8-4.6L VIN 9 (2002)
Seat Cushion: Service and Repair
Seat Cushion Replacement - Front
Seat Cushion Replacement - Front
Tools Required
J 38778 Door Trim Pad and Garnish Clip Remover
Removal Procedure
1. Disable the SIR. Refer toDisabling the SIR System in SIR.
Caution: Refer toSIR Handling Caution in Cautions and Notices.
2. Adjust the front seat to the up position until maximum travel is reached.
Angle the front of the seat cushion up in order to access the seat cushion fasteners.
3. Remove the fasteners retaining the cushion to the seat adjuster.
4. Disconnect the heated seat cushion electrical connectors and the lumbar air lines, if equipped.
5. Disconnect the heated seat module and the memory seat module electrical connectors if equipped.
6. Remove the knobs from the switch.
7. Remove the 2 push pins from the inside of the switch trim plate, on the bottom edge of the trim plate.
8. Release the tabs at the bottom of the switch plate.
9. Remove the switch trim plate.
10. Remove the J channels from the seat cushion.
11. Pull the front seat cushion cover up in order to expose the seat switch.