DeVille DTS V8-4.6L VIN 9 (2002)
1. Replace the wheel speed sensor jumper harness.
2. Route the wheel speed sensor jumper (1) through the engine compartment to the wheel well.
3. Install the air cleaner.
4. Raise the vehicle. Refer to Vehicle Lifting.
5. Install the wheel speed sensor connector (7) to the wheel speed sensor (6).
6. Install the harness grommet (3) to the strut bracket (5).
7. Install the harness grommet (1) to the rail bracket (2).
8. Install the harness clip (4) the rail bracket (2).
9. Install the left front wheel.
10. Lower the vehicle. Refer to Vehicle Lifting.
11. Perform the ABS Diagnostic System Check.