DeVille DTS V8-4.6L VIN 9 (2002)
5. Remove the plugs in the brake hose end.
Important: Install NEW copper brake hose gaskets.
6. Assemble the brake hose bolt and the NEW copper brake hose gaskets to the brake hose.
7. Install the brake hose to caliper bolt to the brake caliper.
^
Tighten the brake hose to caliper bolt to 45 Nm (33 ft. lbs.).
8. Bleed the brake system.
9. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
10. Slowly release the brake pedal.
11. Wait 15 seconds, then repeat steps 9-10 until a firm brake pedal apply is obtained; this will properly seat the brake caliper pistons and brake pads.
12. Install the tire and wheel assembly.
13. Lower the vehicle.
