DeVille DTS V8-4.6L VIN 9 (2002)
6. Pivot the brake caliper down over the brake pads and into the brake caliper bracket.
7. Apply a thin coat of high temperature silicone lube to the rear brake caliper bolts.
Notice: Refer to Fastener Notice in Service Precautions.
8. Install the brake caliper pin bolts.
^
Tighten the brake caliper pin bolts to 31 Nm (23 ft. lbs.).
9. Install the tire and wheel assembly.
10. Lower the vehicle.
11. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
12. Slowly release the brake pedal.
13. Wait 15 seconds, then repeat steps 11-12 until a firm brake pedal apply is obtained; this will properly seat the brake caliper pistons and brake pads.
14. Fill the brake master cylinder reservoir to the proper level.
15. Burnish the pads and rotors.
