DeVille DTS V8-4.6L VIN 9 (2002)
8. Install the 2 master cylinder brake pipes (1) to the BPMV (2) using the locations recorded during the removal procedure.
^
Tighten the 2 brake pipes to 15 Nm (11 ft. lbs.).
Notice: To prevent equipment damage, never connect or disconnect the wiring harness connection from the EBCM with the ignition switch in the ON
position.
9. Connect the EBCM electrical connector (1) to the EBCM (4).
10. Rotate the EBCM connector tab (2) down to the locked position.
11. Install the EBCM connector position assurance (2) to the EBCM electrical connector (1).
12. Install the left front fascia extension.
13. Install the front air deflector.
14. Install the left front wheel.
15. Lower the vehicle. Refer to Vehicle Lifting.
16. Perform the Auto Bleed Procedure.
17. Perform the ABS Diagnostic System Check.
