DeVille DTS V8-4.6L VIN 9 (2002)
Parking Brake Pedal: Service and Repair
Park Brake Pedal Assembly Replacement
Removal Procedure
1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Ensure the park brake pedal is in the full returned position.
3. Pull down on the front park brake cable.
4. Remove the cable (3) from the cable connector (1).
5. Lower the vehicle.
6. Remove the left closeout/insulator.
7. Remove the left knee bolster.
8. Remove the left carpet retainer.
9. Pull back the carpet.
10. Remove the park brake pedal assembly mounting nuts (1, 2).
11. Position the park brake pedal assembly away from the mounting studs.
12. Disconnect the electrical connector from the park brake lever.
13. Remove the front park brake cable from the park brake pedal assembly.
14. Remove the park brake pedal assembly.
Installation Procedure