DeVille DTS V8-4.6L VIN 9 (2002)
9. Remove the coolant heater cord clips (3) from the fuel injector sight shield studs.
10. Remove the coolant heater cord (2) from the vehicle.
Installation Procedure
1. Install the coolant heater cord (2) to the vehicle.
2. Place the coolant heater cord clips (3) over the fuel injector sight shield studs.
3. Tie a new coolant heater cord strap (1) to the engine wiring harness at the front of the engine.
4. Connect the coolant heater cord (1) to the left coolant heater (3).
5. Tie new coolant heater cord straps (2) to the engine wiring harness at the rear of the engine.
6. Secure the excess coolant heater cord (1) to the loom at the fuel rail support bracket.
7. Raise and support the vehicle. Refer to Vehicle Lifting.
