DeVille DTS V8-4.6L VIN 9 (2002)
1. The mode door levers must be in the this position in order to reassemble the mode actuator to the HVAC case.
2. Lubricate the pivots on the mode door levers and the channels on the mode motor cam before reassembling.
3. Align the mode door levers with the cam slots, as noted on disassembly.
4. Install the mode actuator to the HVAC module.
NOTE: Refer to Fastener Notice in Service Precautions.
5. Install the mode actuator retaining screws (1).
Tighten
Tighten the screws to 1.4 N.m (12 lb in).
6. Install the IP carrier.
7. Recalibrate the actuators. Refer to Body Control Module (BCM) Programming/RPO Configuration (DIM) or Body Control Module (BCM)
Programming/RPO Configuration (IPM) or Body Control Module (BCM) Programming/RPO Configuration (RIM) in Body Control System.
Mode Actuator Replacement - Auxiliary
REMOVAL PROCEDURE
