DeVille DTS V8-4.6L VIN 9 (2002)
1. Install the blower motor control processor (1) to the lower mounting location.
The processor once in position should seat flat against the HVAC case.
2. Route and reconnect the electrical connectors to the blower control processor (1) and the blower motor (2).
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the blower motor control processor retaining screw.
Tighten
Tighten the screws to 1.4 N.m (12 lb in).
4. Position the DIM module bracket to its original position.
5. Install the rear two DIM module bracket retaining screws.
6. Install the DIM module into the bracket.
7. Install the right sound insulator.
8. Install the IP compartment.
