DeVille DTS V8-4.6L VIN 9 (2002)
4. Remove the left closeout insulator panel.
5. Squeeze the accelerator control cable (1) cover tangs and push the accelerator control cable through the bulkhead.
6. Disconnect the accelerator control cable (1) at the accelerator controls pedal (3).
7. Remove the accelerator control cable.
INSTALLATION PROCEDURE
NOTE: In order to prevent possible interference and damage, flexible components (hoses, wires, conduits, etc.) must not be routed within 50 mm (2
in) of moving parts, unless the routing is positively controlled.
1. Install the accelerator control cable (3) at the throttle body lever (2).
IMPORTANT: Accelerator control cable must be routed through groove in throttle body lever and seated securely.
2. Install the accelerator control cable (3) at the accelerator controls cable bracket (1).
