DeVille DTS V8-4.6L VIN 9 (2002)
Tighten
Tighten to 42 Nm (31 lb-ft).
38.
Remove the bolt that attaches the bracket to the vapor canister and separate the bracket.
39.
Install the bracket to the NEW vapor canister and install the bolt.
Tighten
Tighten to 6 Nm (53 lb-ft).
40.
Install the new vapor canister and bracket to the body and install the three nuts.
Tighten
Tighten to 6 Nm (53 lb-ft).
41.
Connect the hoses to the vapor canister.
42.
Connect the fuel lines at the fuel filter.
43.
Position the right rear coil spring and raise the rear support assembly to the body.
44.
Install the two rear bolts that attach the rear support assembly to the body.
45.
Position the plate and install the four bolts [(3) 15 mm hex head and (1) 18 mm hex head] at the right front comer of the support assembly.
Tighten
^
Tighten the three 15 mm hex head bolts that attach the plate to the body to 86 Nm (63 lb-ft).
^
Tighten the one 18 mm hex head bolt to 191 Nm (141 lb-ft).
^
Tighten the two support bolts to 191 Nm (141 lb-ft).
46.
Remove the transmission jack or equivalent.
47.
Connect the 7-way electrical connector and attach the harness to the body at the rear of the right wheelhouse.
48.
Position the rear shock absorber lower mount to the lower control arms. Install the bolts.
Tighten
Tighten to 24 Nm (18 lb-ft).
49.
Install the brake calipers and mounting bolts (pins).
Tighten
Tighten to 27 Nm (20 lb-ft).
50.
If equipped, position the harness and park brake cable to the lower controls arms and install the bolt.
Tighten
Tighten to 24 Nm (18 lb-ft).
51.
Connect both rear wheel speed sensor electrical connectors.
52.
On models equipped with continuous variable road sensing suspension, connect the 2-way electrical connector at each lower control arm. Secure
the harness to the lower control arms with the three retainers.
53.
If equipped, connect the automatic level control links to the lower controls arms.
