DeVille DTS V8-4.6L VIN 9 (2002)
3. Remove the fasteners (4) from the rear side inflator module (5).
4. Remove the rear side inflator module.
5. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required
retention period. Refer to Inflator Module Handling and Scrapping.
INSTALLATION PROCEDURE
1. Install new rear side inflator module (5) to the body panel (1).
NOTE: Refer to Fastener Notice in Service Precautions.
IMPORTANT: When reinstalling or replacing rear side inflator module, apply thread locking compound GM P/N 12345493 (Canadian P/N
10953488) or equivalent to the threads of the studs.
2. Install the mounting fasteners (4) to the rear side inflator module.
Tighten
Tighten the fasteners to 9 N.m (80 lb in).
3. Connect the wiring harness (3) from the rear side inflator module to the vehicle wiring harness (2).
4. Install the CPA to the rear side air bag connector (2,3).
5. Install the retaining clip to the air bag connector assembly.
