DeVille DTS V8-4.6L VIN 9 (2002)
Child Seat Tether Attachment: Service and Repair
CHILD RESTRAINT TETHER ANCHOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the rear shelf panel.
2. Remove the rear shelf panel reinforcement.
3. Remove the fastener (2) that retains the child tether anchor (1) that is being serviced.
4. Remove the child tether anchor (1) from the vehicle.
INSTALLATION PROCEDURE
IMPORTANT: During installation ensure that the child tether anchors are installed with the anti-rotation tabs firmly seated in the anti-rotation tab
holes on the cross car beam. The anti-rotation tabs face forward on the outboard anchors. The center child tether anchor (1) and the anti-rotation tabs
face the rear of the vehicle.
1. Install the child tether anchor (1) to the cross car beam.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the child tether anchor fastener (2).
Tighten
Tighten the fastener to 30 N.m (22 lb ft).
3. Install the rear shelf panel carrier.