DeVille DTS V8-4.6L VIN 9 (2002)
Power Door Lock Switch: Removal and Replacement
Front Door Switch Replacement
Removal Procedure
1. Insert a flat bladed tool under the rear edge of the front door switch plate.
Notice: The retainer clip must be fully disengaged before the switch plate is removed. Otherwise, damage to the switch plate could result.
2. Push the tool firmly towards the switch plate in order to disengage the retainer.
3. Lift up on the rear of the switch plate in order to remove it from the door trim panel.
4. Disconnect electrical connectors.
5. Remove the appropriate switch from the switch plate by disengaging the side snap walls with small flat bladed tool.
Installation Procedure
1. Snap the switch into the switch plate.
2. Connect the electrical connectors.
3. Install the switch plate into the door trim panel.
4. Engage the front of the switch plate to the door panel.
5. Press down on the switch plate evenly in order to engage the retainer.
