DeVille DTS V8-4.6L VIN 9 (2002)
Yaw Rate Sensor: Service and Repair
Yaw Rate Sensor Replacement
Removal Procedure
1. Turn OFF the ignition.
2. Remove the rear shelf trim panel.
3. Remove the rear compartment trim.
4. Carefully pull the left trim panel back to access the yaw rate sensor.
5. Remove the 2 yaw rate sensor mounting nuts (1).
6. Remove the yaw rate sensor (3).
7. Disconnect the yaw rate sensor electrical connector (2).
Installation Procedure
1. Connect the yaw rate sensor electrical connector (2).
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the yaw rate sensor (3).
^
Tighten the 2 yaw rate sensor mounting nuts (1) to 6 Nm (53 inch lbs.).
3. Reposition the left trim panel.
4. Install the rear shelf trim panel.
5. Install the rear compartment trim.
6. Perform the ABS Diagnostic System Check.
