DeVille DTS V8-4.6L VIN 9 (2002)
Knock Sensor: Service and Repair
KNOCK SENSOR (KS) REPLACEMENT
REMOVAL PROCEDURE
Locations View
1. Remove the intake manifold.
2. Disconnect the knock sensor electrical connector.
3. Remove the knock sensor (KS).
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
Locations View
1. Install the knock sensor.
Tighten
Tighten the knock sensor to 25 N.m (18 lb ft).
2. Connect the knock sensor electrical connector.
3. Reinstall the intake manifold. Refer to Intake Manifold Replacement in Engine.
