DeVille DTS V8-4.6L VIN 9 (2002)
1. Position the generator to the A/C compressor and engine.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the generator mounting bolts (1,2).
Tighten
Tighten the generator mounting bolts to 50 N.m (37 lb ft).
3. Connect the wiring harness connector to the generator.
4. Connect the battery positive lead and install the generator output BAT terminal nut.
Tighten
Tighten the generator output BAT terminal nut to 12.5 N.m (111 lb in).
5. Press the protective boot on to the generator output BAT terminal.
6. Install the radiator.
7. Install the drive belt.
8. Connect the battery negative cable.
For a description of the RPO Code(s) shown in this article/image, refer to the RPO Code List found at Vehicle/Application ID See: Application and
ID/RPO Codes