DeVille DTS V8-4.6L VIN 9 (2002)
Stabilizer Link: Service and Repair
Rear Suspension
With RPO FE1 and FE3
Stabilizer Shaft Link Replacement (FE1 and FE3)
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the stabilizer shaft link bolt and nut.
3. Remove the stabilizer shaft spacer and insulators.
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
1. Install the stabilizer shaft link insulators, spacer, nut and bolt.
^
Tighten the stabilizer shaft link nut to 15 Nm (11 ft. lbs.).
2. Lower the vehicle.
With RPO FE7
Stabilizer Shaft Link Replacement (FE7)
Removal Procedure