DeVille DTS V8-4.6L VIN 9 (2002)
1. Install the dust shield, taking care not to damage the bearing outboard lip seal. Install the wheel bearing and hub to the drive axle.
2. Install the drive axle nut and draw hub and bearing onto the axle.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the wheel bearing hub and bearing bolts.
^
Tighten the wheel bearing and hub mounting bolts to 152 Nm (112 ft. lbs.).
4. Install the front wheel speed sensor connector and clip to the dust shield.
5. Install the brake rotor.
6. Insert a large, flat bladed tool (1) into the caliper and rotor to prevent the rotor from turning.
^
Tighten the wheel drive shaft nut to 215 Nm (159 ft. lbs.).
7. Install the tire and wheel.
8. Lower the vehicle.