DeVille DTS V8-4.6L VIN 9 (2002)
1. Clean the lower control arm face and bore before installing the wheel bearing and hub.
2. Install the wheel bearing and hub and brake shield to the lower control arm.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the wheel bearing and hub retaining bolts.
^
Tighten the wheel bearing and hub retaining bolts to 68 Nm (50 ft. lbs.).
4. Install the brake rotor.
5. Install the ABS sensor wire connector.
6. Install the tire and wheel.
7. Lower the vehicle.
With RPO FE7
Wheel Bearing/Hub Replacement Rear (FE7)
Removal Procedure
Important: It is necessary to replace the ABS sensor and reluctor when servicing the hub or wheel bearing.
