DeVille DTS V8-4.6L VIN 9 (2002)
Torque Converter Clutch Solenoid: Service and Repair
1. TCC Solenoid Replacement
TORQUE CONVERTER CLUTCH (TCC) SOLENOID
The OE service manual does not provide a specific service and repair procedure for the Torque Converter Clutch (TCC) solenoid, Refer to the
following articles in the specified order;
IMPORTANT: These are Unit Repair articles which are provided for reference only and it may not be necessary to complete every step in each
article for TCC solenoid replacement. It is the responsibility of the technician to determine the proper procedure.
1. TCC Solenoid
2. Transmission Replacement
3. Side Cover, Gasket, and Filter Removal
4. Oil Pump, Upper Control Valve Assembly Removal
5. Upper Control Valve Body Disassemble
6. Upper Control Valve Body Assemble
7. Upper Control Valve Assembly Installation
8. Oil Filter and Side Cover Install
2. Transmission Replacement
Transmission Replacement
^
Tools Required
-
J41623-B Cooler Quick Connect Tool
-
J41160 Transmission Jack Adapter
Removal Procedure
1. Remove the upper filler panel.
2. Remove the upper and lower air cleaner assemblies.
3. Disconnect the range selector cable terminal from the transaxle range selector lever.
4. Remove the nuts securing both the range selector cable bracket and heater pipe to the transaxle.
Position the range selector cable bracket and heater pipe aside.
5. Remove the Magnasteer wire from the retaining clip.
6. Disconnect the master cylinder brake pipe retainers from the side rail.
Important: Supporting the brake pipes above the body side rail is necessary while removing the transaxle in order to prevent pinching of the brake
pipes.
7. Remove the brake pipe retainers from the side rail and using mechanics wire, support the brake pipes above the side rail.
