DeVille DTS V8-4.6L VIN 9 (2002)
24. Install the remaining transaxle to engine bolts (1).
^
Tighten the bolts to 75 Nm (55 ft. lbs.).
25. Remove the engine support fixture.
26. Install the range selector cable bracket to the studs on the transaxle.
27. Install the heater pipe to the stud on the transaxle.
28. Install the nuts that retain the heater pipe and the range selector cable bracket to the transaxle.
^
Tighten the nuts to 25 Nm (18 ft. lbs.).
29. Connect the range selector cable terminal (1) to the transaxle range selector lever.
30. Install the Magnisteer wire to the retaining clip.
31. Connect the transaxle vent tube to the accelerator bracket.
32. Install the Magnisteer wire to the retaining clip.
33. Connect the transaxle vent tube to the accelerator bracket.
34. Install the brake pipe retainers to the side rail.
35. Install the upper and lower air cleaner assemblies.
36. Install the upper filler panel (1).
37. Add DEXRON III transmission fluid as required.
