DeVille DTS V8-4.6L VIN 9 (2002)
Transmission Mount: Service and Repair
Automatic Transmission Mount Bracket Replacement - Rear
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Support the engine assembly with a suitable jack.
3. Remove the nuts (1) securing the transmission mount (2) to the transmission mount bracket (3).
4. Raise the jack allowing the engine assembly to lift from the engine frame slightly.
5. Remove the transmission mount bracket mounting bolts.
6. Remove the transmission mount bracket
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
1. Install the transmission mount bracket and mounting bolts to the engine.
^
Tighten the bolts to 110 Nm (89 ft. lbs.).
2. Lower the transmission in position.