DTS V8-4.6L VIN Y (2006)
5. Remove the HO2S.
INSTALLATION PROCEDURE
IMPORTANT: A special anti-seize compound is used on the HO2S threads. The compound consists of liquid graphite and glass beads. the graphite
tends to burn away, but the glass beads remain, making the sensor easier to remove. New, or service replacement sensors already have the compound
applied to the threads. If the sensor is removed from an exhaust components and if for any reason the sensor is to be reinstalled, the threads must have
anti-seize compound applied before the reinstallation
1. If reusing the old HO2S, coat the threads with anti-sieze compound, GM P/N 12377953 or equivalent.
2. Install the HO2S.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten the sensor to 41 N.m (30 lb ft).
