Eldorado V8-350 5.7L DSL (1984)
Governor: All Technical Service Bulletins
A/T - No 1-2 Upshift, Final Drive Noise
Bulletin No. T
85-72
File in Group
7
Number
118
Corp. Ref. No.
8057402
Date
April '85
SUBJECT:
NO 1-2 UPSHIFT AND/OR SPEEDOMETER INOPERATIVE
MODELS AFFECTED: 1982-1985 ELDORADOS AND SEVILLES
FIGURE 1 - Governor Gear
Some Eldorados and Sevilles may experience a final drive noise and/or loss of drive due to an overheated final drive pinion bearing. A preliminary sign
of this condition could be a loss of upshifts due to a worn governor gear in the transmission (appearing to be "apple cored", refer to Figure 1). Therefore,
the final drive pinion bearings should also be replaced at this time.
Occasionally, the heat that is generated by the bearing may deform the final drive pinion gear shank making it difficult to separate the final drive from
the transmission. Excessive force should not be used in attempting to separate the final drive from the transmission, as case damage may result. To
separate the two assemblies, proceed as follows:
1.
Remove the final drive and transmission as an assembly.
FIGURE 2 - Snap Ring Removal
2.
Upon removal, disassemble the transmission to the point such that the snap ring that retains the output shaft to the input internal gear can be
removed (refer to Figure 2).
3.
Once the snap ring is removed, the final drive can be separated from the transmission with the output shaft remaining in the drive pinion.
4.
Disassemble and repair the final drive using normal procedures as outlined in Section 4C of the Service Information Manual.
