Eldorado V8-4.6L VIN Y (1994)
mixing and application.
1.
Thoroughly clean part by washing with a suitable cleaning solvent to remove all surface contaminates.
Cleaning Solvents: (low VOC alternate material shown in brackets)
a.
DuPont 3919S Prep-Sol/Plastic Cleaner 2319S {3929 Prep-Sol or 3949S Cleaner}
b.
BASF Pre-Kleano 900 (905 Water-Base Prep Cleaner)
c.
PPG Acryli-Clean DX330 or DX103 Multi-Prep (DX380 Low VOC Cleaner)
d.
Sherwin-Williams Kril-Kleen R1-K213 (Aqua-Mate W4K157)
e.
Acme 6089; Rogers 4089 (Acme 87 Aqua-Klix; Rogers 4087; Kle-Car III
f.
Martin-Senour 6387 (6388 Kleanz Easy II}
IMPORTANT:
Previously painted parts that show signs of cracking, peeling, or improper adhesion must be stripped before repainting.
2.
Scuff sand to an even dull appearance the entire surface to be painted with fine (400 grit or finer) sandpaper and feather edge any damaged areas
and rewash.
3.
Apply two thin coats of primer, when required, per top coat manufacturer's recommendation and allow to completely dry before proceeding. (For
most products, approximately 30 minutes.)
4.
Prepare color coat according to the manufacturer's recommendation and apply sufficient double coats to develop the proper shade. For best results,
allow a few minutes dry time between each double coat.
5.
Following is a list of some of the products available for painting flexible plastic: (low VOC alternate material shown in brackets)
^
PPG Flexible Primer - DPX844 {low VOC Plastic Primer DPW 1844}
^
PPG Flexative - DX369 {Elastomeric Additive} or DC950 NCT
^
DuPont 9250S Flex Additive
^
Sherwin-Williams Multi-Flex-V6V299
^
Acme/Rogers Multi-Flex-68/4068
^
Martin-Senour Flex Additive-3084
^
BASF Diamont Flex Agent DF-25; Glassodur Elastifier Additive 521-111
^
R-M 891 Flex
Nylon
Will be supplied in prime. Use the same procedure to refinish as on sheet metal parts.
Acrylonitrile-Butadiene-Styrene (ABS)
No prime required. Paint interior parts with acrylic lacquer.
Polyester Parts (UP, PBTP) Will be supplied in prime and/or black paint. Use the same procedure to refinish or repair as on sheet metal parts.
Polypropylene Interior parts.
1.
Wash surface thoroughly with cleaning solvent.
2.
Apply primer immediately and allow to dry completely before color coating.
3.
Color coat with lacquer or enamel reduced and applied according to the manufacturer's recommendation.
