Eldorado V8-4.6L VIN Y (1994)
New Orifice Tube
Remove or Disconnect
1.
Recover A/C system.
2.
High pressure liquid line from evaporator inlet line.
3.
Orifice tube.
Install or Connect
1.
Lube O-rings with 525 oil.
2.
Orifice tube.
3.
High pressure liquid line from evaporator inlet line.
4.
Recharge A/C system. Refer to bulletin # 531206.
Important:
If a diagnostic trouble code (DTC) for low refrigerant is present after the A/C system is recharged, refer to bulletin # 531206.
Condenser Seals
Remove or Disconnect
1.
Headlamp filler panels.
2.
Oil cooler bracket from condenser. Three nuts.
3.
Loosen upper radiator bracket. Four bolts. This allows for easier installation of the foam seals.
Assemble
1.
Cut two full length foam seals in half. Peel off the paper back and adhere two pieces back to back to make two double-sided seals.
2.
Cut two ten inch pieces from another full length piece of foam seal.
3.
Cut the remainder of the seal into two five inch pieces.
Install or Connect
1.
One of the double sided pieces of foam seal along the right side of the condenser. Refer to Figure 4.
