Eldorado V8-4.6L VIN Y (1994)
Remove or Disconnect (Figure 1)
1. Spark plug wires at Ignition Control Module Assembly.
2. Four electrical connectors at Ignition Control Module.
3. Four bolts retaining ICM Assembly to rear camshaft cover.
4. ICM Assembly from vehicle.
5. Ignition coils from ICM Assembly.
6. ICM from assembly bracket.
Install or Connect (Figure 1)
1. ICM to new assembly bracket.
2. Ignition coils to ICM Assembly.
3. Position "new" ICM Assembly on rear camshaft cover and hand start number 1, 2, and 3 bolts.
4. Hand start remaining bolt # 4 as shown in Figure 1 through eyelet in ground strap.
Tighten
Four bolts to 12 Nm (106 lb.in.).
5. Four electrical connectors at ICM.
6. Spark plug wires at ICM Assembly.
7. Attach bolt through remaining end of ground strap and install in right bank cylinder head (Figure 1).
8. Torque bolt to 11 Nm (97 lb.in.).
SERVICE PARTS INFORMATION:
Refer to the following part numbers when ordering parts for the AM RADIO NOISE condition.
Description
Part Number
Ignition Control Module
10477276
ICM Bracket
10472128
Bolt
11516186
Ground Strap
12164612
NOTE:
Whenever replacement of the Ignition Control Module is necessary on a 1993 to 1994 Northstar Engine, the entire AM RADIO NOISE package