cadillac Workshop Repair Guides

Cadillac Workshop Service and Repair Manuals

All Technical Service Bulletins for Windshield: > < 09-08-48-006|Page 8065
Page 2
background image

Important:

Service Manual sections are given in parentheses.

1.

Remove molding from retainer. Pry loose and pull away from the glass (10-2).

2.

Remove (windshield) pillar garnish moldings (10-9); cowl screen, windshield wiper arms, (8-E) sunshades and roof console (eyeglass holder) to
loosen headliner (10-9); instrument panel upper trim panel (8C).

3.

Rear window: pull back (2) quarter trim panels near rear window, (to gain access to rear defogger).

4.

Disconnect rear window defogger.

5.

Mask off painted area around window frame.

6.

Carefully cut and remove glass.

Notice: 

If urethane cutting is done from the inside, protect the glass blackout area from scrapes and scratches by masking with tape.

7.

Clean and prepare body openings and glass surface according to procedures published in Section 10-2 of the Service Manual.

Installation

1.

Install molding onto glass (10-2).

2.

With the aid of a helper, properly position the window in opening, apply a piece of masking tape over roof and adjacent body pillars. Slit tape at
edge of window. Remove window from position.

3.

Apply urethane to glass sealing surfaces (10-2).

Important: 

Two window primers are provided in urethane adhesive kit, a clear and a black primer. The first and most important primer is the clear. Once
applied, it is important to wipe off excess immediately. This primer dries almost immediately and will stain the viewing area.

4.

With aid of a helper, lift window into window opening using tape guides to carefully place window in proper position.

5.

Press window firmly to "wetout" and set adhesive. Use care to avoid excessive "squeeze out" which causes appearance problems.

6.

Water test window for leaks.

7.

Install remaining garnish moldings, sunshades, roof console, instrument panel upper trim panel, cowl screen, windshield wiper arms, and attach
heated windshield wiring if equipped.

8.

Upon completion of window installation, the vehicle must remain at normal room temperature for six hours to complete proper cure of adhesive.

Warranty Information
For vehicles repaired under warranty, use:

Labor 
Operation

Labor Time

Description

B7540

2.4 hrs

Front Window

B8520

1.7 hrs

Rear Window

All Technical Service Bulletins for Windshield: > < 09-08-48-006|Page 8065