Eldorado Touring V8-4.6L VIN 9 (1998)
INSTALLATION PROCEDURE
1. Position the lock module (3) to the door. Perform the following steps:
A. Hang the module (3) on the studs.
B. Hand start the following components:
^
The nuts.
^
The bolts.
2. Install the 3 fasteners retaining the lock to the door.
NOTICE: Refer to Fastener Notice in Cautions and Notices.
3. Tighten the following components in the proper sequence as shown in the illustration:
A. The nuts.
B. The bolts.
C. TIGHTEN
^
Tighten the nuts to 10 Nm (89 lb in).
^
Tighten the bolts to 10 Nm (89 lb in).
4. Connect the wiring harness.
5. Install the window sash bolts.
6. Install the following components to the lock:
^
The outside handle.
^
The lock rods.
7. Install the water deflector. Refer to "Water Deflector".
8. Install the trim panel. Refer to "Door Trim Panel".
