Escalade ESV RWD V8-6.2L (2010)
Replacement (JD9))Master Cylinder Replacement (JH6) (See: Brake Master Cylinder/Service and Repair/Removal and
Replacement/Master Cylinder Replacement (JH6))Master Cylinder Replacement (Two-mode Hybrid) (See: Brake Master
Cylinder/Service and Repair/Removal and Replacement/Master Cylinder Replacement (Two-Mode Hybrid)); also perform the following:
Clean the brake master cylinder reservoir using denatured alcohol, or equivalent, then dry the reservoir using non-lubricated, filtered air.
Inspect the reservoir for cracks and/or damage and replace if necessary. Refer to Master Cylinder Reservoir Replacement (Two-mode
Hybrid) (See: Brake Master Cylinder/Service and Repair/Removal and Replacement/Master Cylinder Reservoir Replacement (Two-Mode
Hybrid))Master Cylinder Reservoir Replacement (JD9) (See: Brake Master Cylinder/Service and Repair/Removal and
Replacement/Master Cylinder Reservoir Replacement (JD9))Master Cylinder Reservoir Replacement (JH6) (See: Brake Master
Cylinder/Service and Repair/Removal and Replacement/Master Cylinder Reservoir Replacement (JH6)).
Replace the brake master cylinder reservoir cap diaphragm.
*
Front Brake Hose Replacement (JH6) (See: Brake Hose/Line/Service and Repair/Front Brake Hose Replacement (JH6))Front Brake Hose
Replacement (JD9) (See: Brake Hose/Line/Service and Repair/Front Brake Hose Replacement (JD9))
*
Rear Brake Hose Replacement (JH6) (See: Brake Hose/Line/Service and Repair/Rear Brake Hose Replacement (JH6))Rear Brake Hose
Replacement (Frame to Rear Axle JH6) (See: Brake Hose/Line/Service and Repair/Rear Brake Hose Replacement (Frame to Rear Axle
JH6))Rear Brake Hose Replacement (Frame to Rear Axle JD9) (See: Brake Hose/Line/Service and Repair/Rear Brake Hose Replacement
(Frame to Rear Axle JD9))Rear Brake Hose Replacement (JD9) (See: Brake Hose/Line/Service and Repair/Rear Brake Hose
Replacement (JD9))
*
Front Brake Caliper Overhaul (2500 Series) (See: Brake Caliper/Service and Repair/Overhaul/Front Brake Caliper Overhaul (2500
Series))or Front Brake Caliper Replacement (2500 Series) (See: Brake Caliper/Service and Repair/Removal and Replacement/Front
Brake Caliper Replacement (2500 Series))Front Brake Caliper Replacement (1500 Series) (See: Brake Caliper/Service and
Repair/Removal and Replacement/Front Brake Caliper Replacement (1500 Series))
*
Rear Brake Caliper Overhaul (2500 Series) (See: Brake Caliper/Service and Repair/Overhaul/Rear Brake Caliper Overhaul (2500 Series)
)or Rear Brake Caliper Replacement (2500 Series) (See: Brake Caliper/Service and Repair/Removal and Replacement/Rear Brake
Caliper Replacement (2500 Series))Rear Brake Caliper Replacement (1500 Series) (See: Brake Caliper/Service and Repair/Removal and
Replacement/Rear Brake Caliper Replacement (1500 Series))
*
Brake Pressure Modulator Valve Replacement ()Two-mode Hybrid
*
Brake Pressure Modulator Valve Replacement (See: Hydraulic Control Assembly - Antilock Brakes/Service and Repair/Less than 3900
kg (8600 lb) GVW)Non-Hybrid Less than 3900 kg (8600 lb) GVW
*
Brake Pressure Modulator Valve Replacement (See: Hydraulic Control Assembly - Antilock Brakes/Service and Repair/Greater
than/Equal to 3900 kg (8600 lb) GVW)Non-Hybrid Greater than/Equal to 3900 kg (8600 lb) GVW
4. If the brake fluid was NOT contaminated with an oil-based or a silicone-based substance, but WAS contaminated with water or dirt, rust,
corrosion, and/or brake dust, replace the brake master cylinder reservoir cap diaphragm. The diaphragm may have allowed the moisture or
particles to enter the hydraulic system.
5. Fill the brake master cylinder reservoir to the maximum-fill level with Delco Supreme 11(R), GM P/N 12377967 (Canada P/N 992667) or
equivalent, DOT-3 brake fluid from a clean, sealed brake fluid container.
6. Pressure bleed the hydraulic brake system. Begin the procedure with the pressure bleeder reservoir filled to the maximum-fill level with the correct
brake fluid as indicated. Refer to Hydraulic Brake System Bleeding (Manual) (See: )Hydraulic Brake System Bleeding (Pressure) (See: ).
