Escalade ESV RWD V8-6.2L (2010)
13. Remove the slide pin boots (4) from the caliper bracket.
14. Inspect the disc brake hardware. Refer to Rear Disc Brake Mounting and Hardware Inspection (See: Disc Brake System/Testing and
Inspection/Rear Disc Brake Mounting and Hardware Inspection).
Installation Procedure
1. Lubricate the caliper bracket bushings and the slide pins with high temperature silicone brake lubricant.
2. Install the slide pin boots (4) to the caliper bracket.
3. Install the slide pins (5) to the caliper bracket (3).
4. Install the anti-rattle clips to the caliper bracket.
5. Install the brake pads.
6. Install the caliper to the caliper bracket.
7. Perform the following procedure before installing the caliper bracket bolts and the brake caliper bolts:
1. Remove all traces of the original adhesive patch.
2. Clean the threads of the bolt with brake parts cleaner or the equivalent and allow to dry.
3. Apply Threadlocker GM P/N 12345493 (Canadian P/N 10953488) to the threads of the bolt.
8. Install the brake caliper bolts. DO NOT tighten.
